3Dプリンター用に簡単にデータをカットする方法

No time to watch the complete video? Jump to the topics of your interest. Have a look at the time stamps below.

• Find the Cut or Punch tool 0:40
• Polyline cut 0:45
• Polyline rounding 1:23
• Polyline teeth and clearances 2:17
• Basic section cut 3:17
• Lap joint cut 4:04
• Connector pins/holes 6:20

1. Select your part(s).
2. Go to Tools >> Cut or Punch.
3. To cut through a polyline, click on Indicate Polyline, draw the polyline, and click on Apply.
4. To round up the corners of a polyline, click on Round Polyline.
5. To leave space for the glue during reassembly, you can enable Clearance. Clearance can be on the inside, outside, or both sides of the cut line.
6. You can add teeth to your polyline to facilitate reassembly. Click on Select teeth lines, click on the line. Select the teeth type, size, and offset. Click on Apply and Apply again.
7. You can also use the section views to apply cuts. Go to the View Pages >> Multi-Section and enable the section view of your choosing.
   1. The Basic option will apply a basic cut through the defined section.
   2. The Lap Joint cut option will create an L-shaped profile with a protrusion on one half, and a depression on the other half. This profile can be applied throughout the whole contour, or only a part of the contour between two points that you can define.
   3. The Connector Pins/Holes will create holes on one half, and create pins that will fit in these holes on the other half.
8. Click on Apply.